iThenticate Please note that all the papers submitted to JAFM, after revision and prior to acceptance, will be checked with iThenticate, a powerful plagiarism detection software, in order to guarantee the quality of papers being published in JAFM. The papers with 20% or more similarities with any other published journal papers will be rejected.
Become a referee
Published Volumes
Recent Volume

Recent Volume

2019 Vol. 12, No. 4

Welcome to the JAFM online scientific journal system

JAFM is indexed in:

ISI (Thomson Reuters) IF (2018)= 0.918

Science Citation Index Expanded (SciSearch)
Journal Citation Reports/Science Edition
Current Contents/Engineering Computing Technology

SCOPUS    SNIP (2018): 0.708  SJR (2018): 0.367 CiteScore (2018): 1.22


Ulrich's Periodicals Directory

AJC        ISC        SID
 Open Access

Journal of Applied Fluid Mechanics

ISSN: 1735-3572    EISSN: 1735-3645


Prof. Ahmad Reza Pishevar


Editorial Manager

Dr. Mohammad Reza Tavakoli

Editorial Assistant

Ms. Shakiba Rostami


JAFM is an open access, peer-reviewed online journal with a scope that covers all aspects of theoretical, numerical and experimental fluid mechanics. The emphasis is on the applied rather than purely mathematical aspects of fluid mechanics.


JAFM offers a rapid and high quality peer-review process overseen by its distinguished international Editorial Board. The journal benefits from an efficient online submission process and online publication upon acceptance.


JAFM papers are freely available and the accepted papers are published free of cost.


For further assistance for submitting manuscripts, the JAFM secretary may be contacted by the following email address:



Most Viewed Papers
Vol1 , No 2
Back to list
Title : Water Local Volume Fraction on Oil in Water Dispersion
Pages : 57-63
Authors : siti aslina hussain,  Xiao Y. Xu,  Geoffrey F. Hewitt, 
Anstract : The phase distribution of water-oil flows was studied experimentally from a separated flow without mixer to a oil in water or water in oil dispersed in horizontal tubes. Under most conditions the pattern was oil continuous in water dispersed or water continuous in oil dispersed flow continuously and there is entrainment in the form of drops of phase into the other. The investigations were carried out through the cross-sectional phase distribution in the flow of mixtures of water and kerosene such as EXXSOL-D80 in a horizontal 25.4 mm bore stainless steel section. The phase fraction distribution was determined using a traversing beam gamma densitometer, with the beam being traversed in three directions (00, 450 and 900 of the vertical line passing through the axis of the tube). Measurements were made at three positions spaced along the 9.7 m test section length (1.0 m, 5.85 m and 7.72 m along the horizontal tube). The measurements were done in the Two-phase Oil Water Experimental Rig (TOWER) facility. This facility allows the two fluids to be fed to the test section before they are separated and returned once more to the test line. The flow developed naturally from an initial stratified flow in which the oil and water were introduced separately at the top and the bottom of the test section respectively. It was found that the liquids were fully inter-dispersed by the end of the test section. The results were also used to define the flow patterns in water-oil liquid-liquid flow system. The phase fraction distribution was shown to be homogeneously mixed near to the outlet of the test section.