Numerical Study of the L/D Ratio and Turbulent Prandtl Number Effect on Energy Separation in a Counter-Flow Vortex Tube

Document Type : Regular Article

Authors

1 University of Belgrade, Faculty of Mechanical Engineering, Kraljice Marije 16, 11120 Belgrade 35, Serbia

2 University of Novi Sad, Faculty of Technical Sciences, Trg Dositeja Obradovića 6, 21102 Novi Sad, Serbia

Abstract

Vortex tube is a device without moving parts with ability to separate pressurized gas into two streams: cold and hot. This is a consequence of the Eckert-Wiese effect, which is responsible for spontaneous redistribution of total energy within the flow domain. In order for vortex tubes to work properly, there are some constraints which have to be fulfilled. The most important constraint in that sense is the L/D ratio. One part of this paper is dedicated to the research of the influence of L/D ratio on the energy separation in a vortex tube, i.e. to the values of total temperatures on cold and hot outlets of the device. On the other hand, experimental research of the inner flow is quite challenging since vortex tube is a device of small dimensions. Hence, we are relaying on numerical computations. One of important quantities that has to be prescribed in these computations is the turbulent Prandtl number PrT. Because of that, the other part of this paper is dedicated to research of the influence of PrT on the results of numerical computations. The research is conducted using open-source software OpenFOAM. Turbulence is modelled using two-equation and RST models. For small L/D ratios there is a secondary circulation that acts as a refrigeration cycle, and for greater L/D ratios distribution of velocity and temperature inside the vortex tube remains the same, regardless of the stagnation point presence. It is not justified to increase the length of the vortex tube beyond 20D since the change in cold total temperature inside the vortex tube as well at the cold outlet is practically null. For L/D variation from 1.8 to 10, the cold outlet temperature changes from 270.9 K to 266.8 K, and then rises to its final value of 270.5 K. For L/D ratio from 20 to 60, the total temperature at cold end remains unchanged at 271.3 K. We obtained good results with the unit value of turbulent Prandtl number, and demonstrated that increasing the PrT beyond unit value is not necessary in order to numerically obtain the energy separation inside the vortex tube.

Keywords

References

Ahlborn, B. K. and J. M. Gordon (2000). The vortex tube as a classic thermodynamic refrigeration cycle, Journal of Applied Physics 88(6), 3645-3653,##
Behera, U, P. J. Paul, S. Kasthurirengan, R. Karunanithi, S. Ram, K. Dinesh, and S. Jacob (2005). CFD Analysis and Experimental Investigation Towards Optimizing the Parameters of Ranque-Hilsch Vortex Tube, Int. Journal of Heat and Mass Transfer 48(10), 1961-1973.##
Bruun, H. H. (1969). Experimental Investigation of the Energy Separation in Vortex Tubes, J. Mechanical Engineering Science 11(6), 567-582.##
Burazer, J. M, A. S. Ćoćić and M. R. Lečić (2017). Numerical research of the compressible flow in a vortex tube using OpenFOAM software, Thermal Science 21(Suppl. 3), S745-S758.##
Burazer, J. M, Đ. M. Novković, D. M. Knežević and M. R. Lečić (2019). Numerical research of compressible turbulent swirl flow with energy separation in a cylindrical tube, FME Transactions 47(1), 16-22.##
Burazer, J. M. (2018). Energy separation in transient and steady-state flow across the cylinder, Theoretical and Applied Mechanics 45(1), 83-94.##
Burazer, J. M. (2017, June). Numerical research of energy separation in a cylinder wake, in Proceedings of the 6th International Congress of Serbian Society of Mechanics, Turbulence Minisymposium, Mountain Tara, Serbia, Paper M2i, 8 pages##
Burazer, J. M. (2017). Turbulent compressible flow in a Ranque-Hilsch vortex tube, Doctoral Dissertation, Faculty of Mechanical Engineering, University of Belgrade, Belgrade, Serbia (in Serbian)##
Dincer, K, S. Baskaya and B. Z. Uysal (2008). Experimental investigation of the effect of length to diameter ratio and nozzle number on the performance of counter flow Ranque-Hilsch vortex tube, Heat Mass Transfer 44(3), 367-373.##
Eiamsa-ard, S. and P. Promvonge (2008). Review of Ranque-Hilsch effects in vortex tubes, Renewable and Sustainable Energy Reviews 12(7), 1822-1842.##
Fröhlingsdorf, W. and H. Unger (1999). Numerical Investigations of the Compressible Flow and the Energy Separation in the Ranque-Hilsch Vortex Tube, International Journal of Heat and Mass Transfer 42(3), 415 - 422.##
Greenshields, C. J. (2015). OpenFOAM, The Open Source CFD Toolbox User Guide. Version 3.0.1, CFD Direct Ltd.##
Kays, W. M. (1994). Turbulent Prandtl number – Where are we? Transactions of ASME. Journal of Heat Transfer, 116(2), 284-295.##
Kumar, S. A. and S. A. Lal (2021). Effects of Prandtl number on three dimensional coherent structures in the wake behind a heated cylinder, Journal of Applied Fluid Mechanics, 14 (2), 515-526.##
Launder, B. and B. Sharma (1974). Application of the Energy Dissipation Model of Turbulence to the Calculation of Flows Near a Spinning Disk, Letters in Heat and Mass Transfer 1(2), 131-138.##
Menter, F. and T. Esch (2001, November). Elements of Industrial Heat Transfer Predictions, Proceedings of COBEM 2001, Invited Lecture, Uberlandia, Minas Gerais, Brazil, Vol. 20, 117-127##
Saidi, M. H. and M. S. Valipour (2003). Experimental modeling of a vortex tube refrigerator, Applied Thermal Engineering 23(15), 1971-1980.##
Singh, P. K, R. G. Tathgir, G. Dasaroju and G. S. Grewal (2004). An experimental performance evaluation of vortex tube, Journal of the Institution of Engineers (India): Mechanical Engineering Division 84(4), 149-153.##
Tanweer, S, A. Dewan and S. Sanghi (2019). Study on effects of Prandtl number on cross buoyancy flow past a square cylinder using OpenFOAM, Journal of Applied Fluid Mechanics, 12 (1), 257-269.##
Vodret, S, D. Vitale Di Maio and G. Caruso (2014). Numerical simulation of turbulent forced convection in liquid metals, Journal of Physics: Conference Series 547 012033.##
Yilmaz, M, M. Kaya, S. Karagoz and S. Erdogan (2009). A review on design criteria for vortex tubes, Heat Mass Transfer 45(5), 613-632.##
Journal of Applied Fluid Mechanics
Volume 15, Issue 5 - Serial Number 67
September and October 2022
Pages 1503-1511

Files

Cited by

History

  • Received: 11 March 2022
  • Revised: 16 May 2022
  • Accepted: 30 May 2022
  • Available online: 03 July 2022

Share

How to cite

Statistics