Numerical Simulation of Inlet Void Fraction Affecting Oil-gas Two-phase Flow Characteristics in 90° Elbows

Document Type : Regular Article

Authors

1 School of Aero-engine, Shenyang Aerospace University, Shenyang, Liaoning, 110136, China

2 Key Laboratory of Power Transmission Technology on Aero-engine, aero-engine corporation of China, Shenyang, Liaoning, 110066, China

3 Shenyang Medical College, Shenyang, Liaoning, 110136, China

Abstract

Air can have an adverse effect on the performance of an aero-engine lubrication system. A numerical analysis was conducted to explore the influence of inlet void fraction and pipe layout on the characteristics of oil-gas two-phase flow in a 90° elbow. The pipes were arranged horizontally and vertically with inlet void fractions of 0.05-0.15. The laws governing flow velocity, void fraction, and pressure along the pipe were determined separately. The results revealed the formation of large-scale vortices with high gas volume fractions inside both types of elbows, which exacerbate oil-gas separation and cause additional head loss. The maximum pressure drop was observed at approximately one pipe diameter downstream of the elbow outlet, which initially increases with the inlet void fraction and then gradually stabilizes. Asymmetric secondary flow vortices in the horizontal elbow were found to enhance oil-gas separation and accelerate lubricating oil to greater extent than in a vertical elbow under the same conditions. Consequently, the maximum pressure drop caused by flowing through the horizontal elbow is higher than that in the vertical elbow.

Keywords

Main Subjects


Al-Safran, E., & Al-Qenae, K. (2018). A study of flow-pattern transitions in high-viscosity oil-and-gas two-phase flow in horizontal pipes. SPE Production & Operations, 33(02), 269–280. https://doi.org/10.2118/187939-PA
Atif, A., & Senouci, S. (2019). Numerical analysis of performance deterioration of a centrifugal pump operating in two-phase flows. Journal of Applied Fluid Mechanics, 12(4), 1203-1211. https://doi.org/10.29252/jafm.12.04.29477
Ban, S., Pao, W., & Nasif, M. S. (2018). Numerical simulation of two-phase flow regime in horizontal pipe and its validation. International Journal of Numerical Methods for Heat & Fluid Flow, 28(6), 1279-1314. https://doi.org/10.1108/HFF-05-2017-0195
Bowden, R. C., Lessard, E., & Yang, S. K. (2018). Void fraction measurements of bubbly flow in a horizontal 90 degrees bend using wire mesh sensors. International Journal of Multiphase Flow, 99, 30-47. https://doi.org/10.1016/j.ijmultiphaseflow.2017.09.009
Bressani, M., & Mazza, R. A. (2018). Two-phase slug flow through an upward vertical to horizontal transition. Experimental Thermal and Fluid Science, 91, 245-255. https://doi.org/10.1016/j.expthermflusci.2017.10.023
Chen, Q., Podila, K., Rao, Y. F., Bowden, R., & Yang, S. K. (2019). Assessment of CFD for unheated gas-liquid flows with high void fraction. Nuclear Engineering and Design, 341, 346-359. https://doi.org/10.1016/j.nucengdes.2018.11.016
Chisholm, D. (1980). Two-phase flow in bends. International Journal of Multiphase Flow, 6(4), 363-367. https://doi.org/10.1016/0301-9322(80)90028-2
Dang, Z. R., Yang, Z. J., Yang, X. H., & Ishii, M. (2018). Experimental study of vertical and horizontal two-phase pipe flow through double 90 degree elbows. International Journal of Heat and Mass Transfer, 120, 861-869. https://doi.org/10.1016/j.ijheatmasstransfer.2017.11.089
Debnath, R., Mandal, A., Majumder, S., Bhattaeharjee, S., & Roy, D. (2015). Numerical analysis of turbulent fluid flow and heat transfer in a rectangular elbow. Journal of Applied Fluid Mechanics, 8(2), 231-241. https://doi.org/10.18869/acadpub.jafm.67.221.21363
Fang, L., Wang, S., Li, S., Faraj, Y., Tian, J., & Li, X. (2020). Phase content and flow measurement of bubble flow based on new experimental pipe. Journal of Applied Fluid Mechanics, 13(2), 469-478. https://doi.org/10.29252/jafm.13.02.30344
Flouros, M., Hendrick P., Outirba, B., Cottier, F., & Proestler, S. (2015). Thermal and flow phenomena associated with the behavior of brush seals in aero engine bearing chambers. Journal of Engineering for Gas Turbines and Power-Transactions of the ASME, 137(9), 1-12. https://doi.org/10.1115/1.4029711
Flouros, M., Kanarachos, A., Yakinthos, K., Salpingidou, C., & Cottier, F. (2016). Two-phase flow pressure drop in corrugated tubes used in an aero-engine oil system. Journal of Engineering for Gas Turbines and Power-Transactions of the ASME, 138(6), 1-22. https://doi.org/10.1115/1.4031627
Kim, H. G., & Kim, S. M. (2022). Experimental investigation of flow and pressure drop characteristics of air-oil slug flow in a horizontal tube. International Journal of Heat and Mass Transfer, 183, 122063. https://doi.org/10.1016/j.ijheatmasstransfer.2021.122063
Kong, R., Qiao, S. X., Kim, S., Bajorek, S., Tien, K., & Hoxie, C. (2018). Interfacial area transport models for horizontal air-water bubbly flow in different pipe sizes. International Journal of Multiphase Flow, 106, 46-59. https://doi.org/10.1016/j.ijmultiphaseflow.2018.05.009
Liu, Z. M., Liu, J., & Shen F. (2015). Simulation on flow patterns and characteristics of two-phase gas-liquid flow in a 90° bend under different gravity. Chinese Journal of Theoretical and Applied Mechanics, 47(2), 223-230. https://doi.org/10.6052/0459-1879-14-264
Li, Y. J., Yu, Z. Y., Ye, Q. Y., Yang, J. X., & Hayat, S. (2022). Analysis of pressure fluctuations for oil-gas two-phase flow in a horizontal pipe using the bubble number density equation. Chemical Engineering Communications, 209(3), 351-364. https://doi.org/10.1080/00986445.2020.1869950
Ogunsesan, O. A., Hossain, M., & Droubi, M. G. (2021). Computational fluid dynamics modelling of multiphase flows in double elbow geometries. Proceedings of the Institution of Mechanical Engineers Part E-Journal of Process Mechanical Engineering, 235(6), 1835-1846. https://doi.org/10.1177/09544089211021744
Pour, S. S., Mohanarangam, K., Vahaji, S., Cheung, S., & Tu, J. Y. (2018). Visualization of gas-liquid bubbly flows in a large diameter pipe with 90 bend. Journal of Visualization, 21(4), 585-596. https://doi.org/10.1016/10.1007/s12650-018-0486-2
Qiao, S. X., & Kim, S. (2016). Interfacial area transport across a 90 degrees vertical-upward elbow in air-water bubbly two-phase flow. International Journal of Multiphase Flow, 85, 110-122. https://doi.org/10.1016/j.ijmultiphaseflow.2016.05.015
Qiao, S. X., Mena, D., & Kim, S. (2017). Inlet effects on vertical-downward air-water two-phase flow. Nuclear Engineering and Design, 312, 375-388. https://doi.org/10.1016/j.nucengdes.2016.04.033
Qiao, S. X., & Kim, S. (2018). On the prediction of two-phase pressure drop across 90 degrees vertical elbows. International Journal of Multiphase Flow, 109, 242-258. https://doi.org/10.1016/j.ijmultiphaseflow.2018.08.002
Schiller, L., & Naumann, Z. A. (1935). A drag coefficient correlation. Zeitschrift des Vereins Deutscher Ingenieure, 77, 318–320. https://www.researchgate.net/publication/307884096_A_drag_coefficient_correlation
Yang, H., Xue, J., Li, L., Li, X., Lin, P., & Zhu, Z. (2022). Modeling of bubbly flow using a combined volume of fluid and discrete bubble model: investigation on interphase forces. Journal of Applied Fluid Mechanics, 15(3), 843-855. https://doi.org/10.47176/JAFM.15.03.33280
Yayla, S., Kamal, K., & Bayraktar, S. (2019). Numerical analysis of a two-phase flow (oil and gas) in a horizontal separator used in petroleum projects. Journal of Applied Fluid Mechanics, 12(4), 1037-1045. https://doi.org/10.29252/jafm.12.04.29318
Zahedi, R., & Rad, A. B. (2022). Numerical and experimental simulation of gas-liquid two-phase flow in 90-degree elbow. Alexandria Engineering Journal, 61(3), 2536-2550. https://doi.org/10.1016/j.aej.2021.07.011
Zubir, M. A., Ramli, R., & Zainon, M. Z. (2019). Determination of flow patterns in vertical upward two-phase flow channel via void fraction profile. Journal of Applied Fluid Mechanics, 12(2), 474-483. https://doi.org/10.29252/jafm.12.02.28351