Experimental Performance Study of a Transcritical CO2 Heat Pump Equipped with a Passive Ejector

Document Type : Regular Article

Authors

CanmetENERGY, Natural Resources Canada, Varennes, Qc, J3X 1P7, Canada

Abstract

This study is dedicated to an experimental investigation of a passive two-phase ejector used as an expander in a transcritical CO2 heat pump. The investigation focused on the impact of the evaporating temperature (Tevap) and the CO2 gas cooler outlet temperature (Tgc-out) on the ejector and the overall cycle performance. The basic cycle without an ejector was also tested as a baseline for comparison. Two ejectors designed with different modeling approaches were tested and compared. The ejector with an enlarged mixing section diameter was selected for subsequent testing due to its improved pressure lift. The optimum primary nozzle position was found to be 4 times the mixing section diameter (Dmix). Although the ejector was designed for specific conditions, the results demonstrate its ability to remain operational under varying conditions with some changes in performance. The ejector’s performance was observed to be dependent on the Tevap, and particularly on the Tgc-out. The pressure lift recorded was in the range of 3.7-6.5 bar, and the lowest value was obtained with the low Tgc-out value (29 °C). Under the tested conditions, the integration of the ejector enhances the performance and the capacity of the heat pump. The ejector cycle improvement is primarily based on improved mass flow rates due to increased compressor suction pressure, reduced compression ratio, and consequently, improved compressor operating conditions. Improvements of up to 18% in heating COP and 20.5% in heating capacity were observed. The study provides valuable insights into enhancing the performance of transcritical CO2 heat pump system by refining ejector design. It explores the behavior of the system across varying conditions, highlighting the significant impact of the ejector-compressor interaction on overall performance. 

Keywords

Main Subjects


Aidoun, Z., Ameur, K., Falsafioon, M., & Badache, M. (2019). Current advances in ejector modeling, experimentation and applications for refrigeration and heat pumps. part 2: two-phase ejectors. Inventions, 4(16), 1–54. https://doi.org/10.3390/inventions4010016
Akagi, S., Wang, J., & Hihara, E. (2004). Characteristics of two-phase ejector with carbon dioxide. 41st National Heat Transfer Symposium of Japan.
Ameur, K., & Aidoun, Z. (2021). Two-phase ejector enhanced carbon dioxide transcritical heat pump for cold climate. Energy Conversion and Management, 243, 114421. https://doi.org/10.1016/j.enconman.2021.114421
Ameur, K., & Aidoun, Z. (2023). A Simple design approach of two-phase ejectors for CO2 transcritical heat pumps. Journal of Applied Fluid Mechanics, 16(10), 1887–1900. https://doi.org/10.47176/jafm.16.10.1833
Arpagaus, C., Bless, F., Schiffmann, J., & Bertsch, S. S. (2016). Multi-temperature heat pumps: A literature review. International Journal of Refrigeration, 69, 437–465. https://doi.org/10.1016/j.ijrefrig.2016.05.014
ASHRAE Guideline 2. (1986). Engineering analysis of experimental data. American Society of Heating, Refrigerating, and Air-Conditioning Engineers, Inc. https://doi.org/ASHRAE Guideline 2-1986 (RA90)
Badache, M., Ouzzane, M., Eslami-Nejad, P., & Aidoun, Z. (2018). Experimental study of a carbon dioxide direct-expansion ground source heat pump (CO2-DX-GSHP). Applied Thermal Engineering, 130, 1480–1488. https://doi.org/10.1016/j.applthermaleng.2017.10.159
Barta, R. B., Groll, E. A., & Ziviani, D. (2021). Review of stationary and transport CO2 refrigeration and air conditioning technologies. Applied Thermal Engineering, 185(August 2020), 116422. https://doi.org/10.1016/j.applthermaleng.2020.116422
Bastani, A., Eslami-Nejad, P., Badache, M., & Nguyen, A. T. A. (2020). Experimental characterization of a transcritical CO2 direct expansion ground source heat pump for heating applications. Energy and Buildings, 212. https://doi.org/10.1016/j.enbuild.2020.109828
Boccardi, G., Botticella, F., Lillo, G., Mastrullo, R., Mauro, A. W., & Trinchieri, R. (2017). Experimental investigation on the performance of a transcritical CO2 heat pump with multi-ejector expansion system. International Journal of Refrigeration, 82, 389–400. https://doi.org/10.1016/j.ijrefrig.2017.06.013
Disawas, S., & Wongwises, S. (2004). Experimental investigation on the performance of the refrigeration cycle using a two-phase ejector as an expansion device. International Journal of Refrigeration, 27(6), 587–594. https://doi.org/10.1016/j.ijrefrig.2004.04.002
Elbel, S., & Hrnjak, P. (2008). Experimental validation of a prototype ejector designed to reduce throttling losses encountered in transcritical R744 system operation. International Journal of Refrigeration, 31(3), 411–422. https://doi.org/10.1016/j.ijrefrig.2007.07.013
Elbel, S., & Lawrence, N. (2016). Review of recent developments in advanced ejector technology. International Journal of Refrigeration, 62, 1–18. https://doi.org/10.1016/j.ijrefrig.2015.10.031
Ersoy, H. K., & Bilir Sag, N. (2014). Preliminary experimental results on the R134a refrigeration system using a two-phase ejector as an expander. International Journal of Refrigeration, 43, 97–110. https://doi.org/10.1016/j.ijrefrig.2014.04.006
Ferrara, G., Ferrari, L., Fiaschi, D., Galoppi, G., Karellas, S., Secchi, R., & Tempesti, D. (2016). Energy recovery by means of a radial piston expander in a CO2 refrigeration system. International Journal of Refrigeration, 72, 147–155. https://doi.org/10.1016/j.ijrefrig.2016.07.014
Giacomelli, F., Mazzelli, F., Banasiak, K., Hafner, A., & Milazzo, A. (2019). Experimental and computational analysis of a R744 flashing ejector. International Journal of Refrigeration, 107, 326–343. https://doi.org/10.1016/j.ijrefrig.2019.08.007
Haida, M., Banasiak, K., Smolka, J., Hafner, A., & Eikevik, T. M. (2016). Experimental analysis of the R744 vapour compression rack equipped with the multi-ejector expansion work recovery module. International Journal of Refrigeration, 64, 93–107. https://doi.org/10.1016/j.ijrefrig.2016.01.017
Lawrence, N., & Elbel, S. (2016). Experimental investigation on the effect of evaporator design and application of work recovery on the performance of two-phase ejector liquid recirculation cycles with R410A. Applied Thermal Engineering, 100, 398–411. https://doi.org/10.1016/j.applthermaleng.2016.01.079
Lawrence, N., & Elbel, S. (2019). Experimental investigation on control methods and strategies for off-design operation of the transcritical R744 two-phase ejector cycle. International Journal of Refrigeration, 106, 570–582. https://doi.org/10.1016/j.ijrefrig.2019.04.020
Lee, J. S., Kim, M. S., & Kim, M. S. (2011). Experimental study on the improvement of CO2 air conditioning system performance using an ejector. International Journal of Refrigeration, 34(7), 1614–1625. https://doi.org/10.1016/j.ijrefrig.2010.07.025
Liu, F., Groll, E. A., & Ren, J. (2016). Comprehensive experimental performance analyses of an ejector expansion transcritical CO2 system. Applied Thermal Engineering, 98, 1061–1069. https://doi.org/10.1016/j.applthermaleng.2015.12.017
Liu, J., Liu, Y., & Yu, J. (2021). Performance analysis of a modified dual-ejector and dual-evaporator transcritical CO2 refrigeration cycle for supermarket application. International Journal of Refrigeration, 131, 109–118. https://doi.org/10.1016/j.ijrefrig.2021.06.010
Lucas, C., & Koehler, J. (2012). Experimental investigation of the COP improvement of a refrigeration cycle by use of an ejector. International Journal of Refrigeration, 35(6), 1595–1603. https://doi.org/10.1016/j.ijrefrig.2012.05.010
Minetto, S., Brignoli, R., Banasiak, K., Hafner, A., & Zilio, C. (2013). Performance assessment of an off-the-shelf R744 heat pump equipped with an ejector. Applied Thermal Engineering, 59(1–2), 568–575. https://doi.org/10.1016/j.applthermaleng.2013.06.032
Sarkar, J. (2015). Review and future trends of supercritical CO2 Rankine cycle for low-grade heat conversion. Renewable and Sustainable Energy Reviews, 48, 434–451. https://doi.org/10.1016/j.rser.2015.04.039
Sarkar, J., Bhattacharyya, S., & Gopal, M. R. (2004). Optimization of a transcritical CO2 heat pump cycle for simultaneous cooling and heating applications. International Journal of Refrigeration, 27, 830–838. https://doi.org/10.1016/j.ijrefrig.2005.12.006
Sengupta, A., & Dasgupta, M. S. (2023). CFD supported thermodynamic analysis of a CO2 pressure exchanger based refrigeration system for supermarkets. International Journal of Refrigeration. https://doi.org/10.1016/j.ijrefrig.2023.04.012
Song, Y., Cui, C., Yin, X., & Cao, F. (2022). Advanced development and application of transcritical CO2 refrigeration and heat pump technology—A review. Energy Reports, 8, 7840–7869. https://doi.org/10.1016/j.egyr.2022.05.233
Wang, J., Belusko, M., Evans, M., Liu, M., Zhao, C., & Bruno, F. (2022). A comprehensive review and analysis on CO2 heat pump water heaters. Energy Conversion and Management: X, 15(July), 100277. https://doi.org/10.1016/j.ecmx.2022.100277
Xu, X. X., Chen, G. M., Tang, L. M., & Zhu, Z. J. (2012). Experimental investigation on performance of transcritical CO2 heat pump system with ejector under optimum high-side pressure. Energy, 44(1), 870–877. https://doi.org/10.1016/j.energy.2012.04.062
Zhang, J. F., Qin, Y., & Wang, C. C. (2015). Review on CO2 heat pump water heater for residential use in Japan. Renewable and Sustainable Energy Reviews, 50, 1383–1391. https://doi.org/10.1016/j.rser.2015.05.083
Zhang, Z., Feng, X., Tian, D., Yang, J., & Chang, L. (2020). Progress in ejector-expansion vapor compression refrigeration and heat pump systems. Energy Conversion and Management, 207(February), 112529. https://doi.org/10.1016/j.enconman.2020.112529
Zhu, Y., Huang, Y., Li, C., Zhang, F., & Jiang, P. X. (2018). Experimental investigation on the performance of transcritical CO2 ejector-expansion heat pump water heater system. Energy Conversion and Management, 167(March), 147–155. https://doi.org/10.1016/j.enconman.2018.04.081