CFD Simulation of In-Cylinder Flow on Different Piston Bowl Geometries in a DI Diesel Engine

Authors

1 Research Scholar, Mechanical Engineering, JNTU Hyderabad, Telangana, India

2 mechanical Department, JNTUA Anantapur, Andhra Pradesh,India

Abstract

The combustion process in the diesel engine should be controlled to avoid both excessive maximum cylinder pressure and an excessive rate of pressure rise, in terms of crank angle. At the same time, the process should be so rapid that substantially all the fuel is burned early in the expansion stroke. In this direction, piston configuration plays a crucial role. Four configurations i.e., flat, inclined, central bowl, and inclined offset bowl piston have been studied. This study is concerned with the CFD analysis has been carried out on two valve four stroke diesel engine to analyze the in-cylinder air motion during suction stroke, pressure and temperature variation inside the cylinder during the compression stroke for various configurations. The engine specifications are considered from the literature. For numerical analysis, Ansys15 CFD software has been used, for meshing polyhedral trimmed cells were adopted. In-cylinder flows were analyzed by solving mass, momentum and energy equation. From this study, it is concluded that analysis has been carried out for each crank angle degree during suction and compression stroke for all the piston configurations, tumble ratio varies mainly with crank angle position. At the end of the compression stroke fuel is injected and the performance of different piston bowls are analyzed.

Keywords

Journal of Applied Fluid Mechanics
Volume 9, Issue 3
April 2016
Pages 1147-1155

Files

Cited by

Share

How to cite

Statistics